EINHELL BG-EC 620 T Instructions d'exploitation télécharger pdf (Page 20)

Sound and vibration

Sound and vibration values were measured in

accordance with EN 60745.

sound pressure level 83 dB(A)

uncertainty 1 dB

sound power level 103 dB(A)

uncertainty 3 dB

Wear ear-muffs.

The impact of noise can cause damage to hearing.

Total vibration values (vector sum of three directions)

determined in accordance with EN 60745.

Handle under load

Vibration emission value ah = 3.47 m/s

K uncertainty = 1.5 m/s

Warning!

The specified vibration value was established in

accordance with a standardized testing method. It

may change according to how the electric equipment

is used and may exceed the specified value in

exceptional circumstances.

The specified vibration value can be used to compare

the equipment with other electric power tools.

The specified vibration value can be used for initial

assessment of a harmful effect.

Reduce noise generation and vibration to a

minimum!

n Use only equipment that is in perfect condition.

n Maintain and clean the equipment regularly.

n Adopt your way of working to the equipment.

n Do not overload the equipment.

n Have the equipment checked if necessary.

n Switch off the equipment when not in use.

n Wear gloves.

8. Maintenance

8.1 Replacing the saw chain and cutter rail

The cutter rail needs to be replaced if

n the guide groove of the cutter rail is worn;

Proceed as described in the section “Assembly of the

cutter rail and the saw chain”.

8.2 Checking the automatic chain lubrication

You should check the operation of the automatic

chain lubrication system on a regular basis in order to

guard against overheating and the associated

damage to the cutter rail and the saw chain. To do

this, point the tip of the cutter rail towards a smooth

surface (board, section of a cut tree) and allow the

chainsaw to run. If an increasing oil trace becomes

evident during this process then the automatic chain

lubrication system is working properly. If no clear oil

trace is evident then please refer to the corresponding

instructions in “Troubleshooting”. If the information

contained there still fails to remedy the situation then

please contact our service department or another

similarly qualified workshop. Important! Do not

actually touch the surface with the tip of the cutter rail

when performing this test. Keep a safe distance

(approx. 20 cm).

8.3 Sharpening the saw chain

Effective working with the chainsaw is only possible if

the saw chain is in good condition and sharp. This

also reduces the risk of kickback. The saw chain can

be re-sharpened by any dealer. Do not attempt to

sharpen the saw chain yourself unless you have the

necessary special tools and experience.

9. Cleaning and storing

n Regularly clean the clamping mechanism by

blowing it out with compressed air or cleaning it

with a brush. Do not use tools for cleaning.

n Keep the handles free of grease so that you can

maintain a firm grip.

n Clean the equipment as required with a damp

cloth and, if necessary, mild washing up liquid.

n If the chainsaw is not to be used for an extended

period of time then you should remove the chain

oil from the tank. Briefly immerse the saw chain

and the cutter rail in an oil bath and then wrap

them in oil paper.

Anleitung_BG_EC_620_T_SPK7__ 10.07.12 13:25 Seite 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 139 140

EINHELL BG-EC 620 T Instructions d'exploitation Page 20

Commentaires sur ces manuels